|
The ART USB PHONO PLUS USB Audio Interface With Standalone Phono Preamplifier. Affordable, Phono Preamp with RIAA EQ and USB Connectivity.
The ART USB PHONO PLUS boasts analog inputs that are switchable between Phono and Line level signals with a low cut filter that removes rumble and wind noise while leaving the audio pristine. The USB Phono Plus front gain trim control and signal/clip LED allow you to optimize the A/D for a wide range of input sources. The front panel USB monitor/headphone jack and the optical output on the rear panel can monitor audio output from your computer. The USB Phono Plus built-in low noise Phono preamp circuit is highly accurate and precisely conforms to the RIAA standard. The Line Output jacks are always connected to the input preamps signal for source monitoring. Housed in an all aluminum black anodized case, the USB Phono Plus can be powered by either an external power source or directly off the USB port so remote recording is a snap. Optical TOSLINK inputs and outputs as well as S/PDIF inputs let you use the USB Phono Plus as a digital audio to USB interface as well. The USB Phono Plus is fully compliant with the USB 1.1 specification and uses USB adaptive mode for playback and USB asynchronous mode for record. It will work with the USB audio device drivers built into Windows 98SE/ME/2000/XP or Macs with native USB support OS9.1 or greater or OSX. No special drivers are needed.
The main features of the ART USB PHONO PLUS include:
Affordable, Phono Preamp with RIAA EQ and USB Connectivity
Left and right analog ins switchable between phono and line with Switchable low-cut filter
Front gain trim with Signal/clip LED
Front-panel USB monitor/headphone jack - 1/8 inch mini jack
Rear optical out
Source monitoring
Optical TOSLINK ins and outs
S/PDIF ins
No special drivers needed
Frequency Response: 10Hz –50KHz, +/-.5dB THD: .01% Typical @ 1KHz
Hum and Noise: >90dB below clipping
Input Impedance: 47k Ohms/100pF (phono) 270k Ohm (line)
Maximum Input Level: 40mVrms @1KHz (phono), +19dBu (line)
Maximum Gain: 45dB @ 1KHz (phono), +6dB (line)
Analog Output Connections: RCA (preamp line output), 1/8 inch jack (USB monitor/headphone output)
Maximum Output Level: +6dBu (1.4Vrms)
Filter Type/Response: Switchable, High Pass, -3dB @ 22Hz
A/D & D/A: 16 bit, 44.1KHz or 48KHz USB selectable
Digital Audio Interface: TOSLINK in and out, S/PDIF coax (RCA) in
Computer Interface: USB 1.1 compliant, Windows 98SE/ME/2000/XP or newer Mac OS9.1 or newer
Power Requirements: 7-12V DC or 9-12V AC @ 150mA, or USB buss powered
Dimensions: 1.75H x 4.2W x 3.5 inches D (44.5mm x 107mm x 89mm)
Weight: 1.35 lbs. (.61kg)
The ART USB PHONO PLUS features high quality components and exceptionally rugged construction
|
|
